Industrial Vibration

DYTRAN Instruments offer a wide range of rugged ground isolated industrial accelerometers, cables and accessories for monitoring machine or process vibration in hostile environments. With all-welded, case isolated, stainless steel hermetically sealed housings and industrial connectors, these sensors offer good stable measurements over a wide range of frequencies. Mainly used for condition monitoring where, for instance, bearing vibration needs to be permanently or periodically monitored, these sensors are available with standard mV/g outputs. Also, available from Hansford Sensors, is a large range of lower cost sensors including 4-20mA output types, and ATEX approved versions. These sensors have many options especially on mounting stud sizes, cables and g ranges.

SERIES DESCRIPTION RANGE F.S. (g)
3019 High frequency, base isolated, stud mount with top 10-32 connector 500
3059 Small general purpose, through hole mount, side 2-pin connector 50
3063 Triaxial type, through hole mount, side 4-pin connector 50
3166 General purpose, through hole mount, side 2-pin connector 10 – 500
3176 General purpose, stud mount, top 2-pin connector 50 or 500
3184/5/7 Accepts immersion proof boot, stud mount, top 2-pin connector 10 or 50
3191/2 Seismic level sensors, stud mount with top 2-pin connector 0.5 – 5
3202 Ring type with centre bolt mount, with side 2-pin connector 10 or 50
3213 Triaxial type, low weight, through hole mount, side 4-pin connector 50
HS-100 General purpose, stud mount, with top 2-pin conn. or integral cable 16-800
HS-100S General purpose, through hole mount, side 2-pin conn. or cable 16-800
HS-100T Stud mount with temperature output, top 3-pin connector or cable 16-800
HS100ST Through hole with temperature output, side 3-pin connector or cable 16-800
HS105/S 250degC temperature, top or side cable with in-line charge amplifier 50
HS109 Triaxial type, through hole mount with side 4-pin connector 50
HS-130 Small stud mount with top 2-pin connector or integral cable design 50
HS160/S Velocity output, stud/bolt mount, top/side 2-pin connector or cable 1000mm/sec
HS-420 4-20mA velocity output sensors, stud mount, top connector or cable 10-100mm/sec
HS-420T 4-20mA velocity output + temperature, stud mount, top connector 10-100mm/sec
HS-421 4-20mA velocity output + AC output, stud mount, top conn. or cable 10-100mm/sec
HS-422 4-20mA vibration output, rms, stud mount, top connector or cable 1g-100g rms
HS-423 Triple output, 4-20mA, ac + temperature, stud mount, top conn. or cable 1g-100g rms

Logo - blue

logo-hansford-sensors

//